Mitsubishi Problems

Wont start, only when bumped, wont turn off, all dash lights on permanently, headlights flash on there own, indicators not working, coming up as no faults when plugged in ?? Any ideas thanks

Dipped headlights very dull main beam is ok

Engine shudders up to 2000 revs

at low revs car shakes really bad and emits grey smoke,had a injector changed,egr,throttle body,fuel filter changed too

Currently touring Italy on holiday from the UK. In high 20's/low 30's Deg C after running for a few hours at 65mph ish, the engine starts to run roughly, feels like a misfire. Also a lot of what sounds like tappet noise. No warning lights. ...

It developed holes along the crank shaft after a few months of hissing sound after first start and while turning when at a complete stop. Afterwards it licked oil and stalled.

Volume turns down instead of up Answer phone it puts it down Indicator flashes as if bulb has blown but all ok

Same as previously posted. The automatic L200 Warror's engin cuts out randomly and the stearing lock. Restart the car and it works again. Happens infrequently, but is worrying when it does.

flywheel works and then wont spin at a certain angle hasnt had any recent changes other than the injectors being removed and put back in

Rear brake on both sides sometimes won`t release after breaking. Not all the time, only sometimes. The pads is touching the disc so the disc gets overheated. After a while when not driving the brakes get back to normal.

Cant switch off stays on standby sold orange light.

Radiator was refilled and coolant refilled and steams after driving, radiator sounds like it’s hissing when engine is turned off

If the car is left idle for a day it's takes multiple cranks to get it to start

My engine makes a noise that sounds like an electric cutter cutting through an aluminium pipe whenever the vehicle is in motion. What can be the cause? This problem has been there for more than a year now

Mitsubishi ASX 2020 4WD petrol 2.0 CVT AS&G not working after replacing the battery at dealer. Nothing flashes in the dashboard. Not even the dealer didn't identify the issue

Will sometimes not accelerate (almost like limp mode) will be ok if turn off and on. No warning lights. Seems to be if not accelerating might just get stuck in No Acceleration?? Help??

Is there something engages in the gearbox when the ignition is on? I was switching off the engine to reset the limp mode while moving and made a noise like a clutch slipping now the jeep will not move in 4h, just attempts to go with clutch ...

Currently losing about 1 litre from cooling system in 30 miles, have pressurised cooling system and can see no external leaks. Engine oil shows no sign of water contamination. Recently had new cylinder head gasket and cylinder head fitted, ...

same as posted but noise is first when slowing the thud when almost stopped then could id be the abs? when the thud it like lets go somthing binding

The alarm sounds every time I indicate and if I go over a sharp bump. It also does it when I lock it and unlock it with the central locking on the key. How can I demobilise the alarm on a 2012 L200? Or even just cut the wire or remove the f...