Citroen Berlingo Gearbox Problems

the speedo and mileage are not working, and it also stalls when going down the gears. have just had new gearbox and clutch fitted and also new front brake pads to the front.

My car was serviced 3 days ago I mentioned to the garage that I thought the battery maybe faulty because it needed a jump start 4 days earlier. The garage found no fault with the battery and suggested the alternator. The car started the nex...

I HAVE BERLINGO 1.4 PETROL ENGINE I HAVE A PROBLEM WITH STARTING .I PUT A FULLY CHARGED BATTERY IN AND IT STARTS NO PROBLEM AND GO TO START IT IN THE MORNING IT WONT START JUMP START AND FIRES UP RIGHT AWAY BATTERY NEW CAN ANYONE HELP THANK...

1.6 HDI CITROEN BERLINGO FIRST THE TURBO WENT THROUGH LACK OF OIL FEED, THEN WE FLUSHED IT WITH THE FORTE ENGINE FLUSH TWICE, PUT YET ANOTHER TURBO ON IT GUESS WHAT IT WENT AGAIN WE GOT ONTO THE SUPPLIERS OH THEY SUFFER WITH THIS PROBLEM WH...

the reversing lights stay on all the time when the ignition is on

it has been in garage for gears and clutch replacement but when turned on there is no rev counter, it pills white smoke from exhurst whilst ticking over seems to struggle. Other lights stall on also e.g parking light, ign lights ect?????

I was told when i bought the van a month ago the rev counter was not working could it be a simple fix like a fuse or could it be sensor on the gearbox,

I found the gearbox linkage is needed i am replacing 2 short and 1 long are they easy to remove the old ones and replace the new ones, now i have found at the end of the gear stick rod a circle with nothing in the middle should there be...

Every time I drive in very wet conditions, puddles everywhere, the car starts 'missing' and wont start if engine turned off. If it was petrol I could deal with it but diesel? Presume water getting at something elecrical but where? Ta.

i am trying to replace the three linkage rods to the gearbox from the top of the vehicle,the problem is i cant seem to get the linkage rods connected to the ball joint as there is not a lot of room there to apply a lot of pressure there, am...