2010 Vauxhall Insignia car shudder/shaking whilst accelerating
Year: 2010
Variant: 2.0 CDTI 160 sri
Categories:
Running Rough, Starting & Power Loss
Can anyone help my insignia I purchased about 7 months ago high milage 130k so new some money was due to be spent the car did have a shake as below but put it down (knowing ) it was ready for a DMF etc as follows
Replaced the dual mass 4 piece kit etc with genuine parts checked all alloys and had new tyres on the front and rear tyres good and rebalanced
Problem when accelerating hard the whole of the car shakes and seems to be worse and getting worse steering wheel is fine no shake ?. It's almost like it's shaking side to side I have checked all suspension etc and it's nice and tight I wondered about the drive shaft support bearing any ideas please
Replaced the dual mass 4 piece kit etc with genuine parts checked all alloys and had new tyres on the front and rear tyres good and rebalanced
Problem when accelerating hard the whole of the car shakes and seems to be worse and getting worse steering wheel is fine no shake ?. It's almost like it's shaking side to side I have checked all suspension etc and it's nice and tight I wondered about the drive shaft support bearing any ideas please
Posted: May 16, 2015 (8 years ago)
Checked engine mountings ?
Posted May 16, 2015 (8 years ago)
All engine mountings good.
The shudder shakes the whole car and is quite fierce if I ease off the pedal it reduces I have tried putting my foot on the clutch and the shudder reduces allot but still there
The shudder shakes the whole car and is quite fierce if I ease off the pedal it reduces I have tried putting my foot on the clutch and the shudder reduces allot but still there
Posted May 16, 2015 (8 years ago)
There was a TSB (TECHNICAL SERVICE BULLETIN ) on vibrations .
Below is bulletin VX released:
Field Remedy: 2692
Subject: Front axle suspension - Vibration
Models: Engines: Option:
Insignia 2009... All
Complaint: Slight vibration between 70 mph and 90 mph.
Cause: Addition of tolerances.
Remedy:
In case of customer complaint please exchange the rear bushing
of both lower front control arms. Improved parts can be ordered at
P&A.
Note: Wheels have to be very well balanced and have to be installed
to the hub according to the information given in TIS.
Spare parts: Part-number: Catalogue-number:
Bushing, damper, front- 13 315 674 3 52 496
suspension arm, rear
Labour Times: TC: Hours:
U3 269 20 Replace bushings 90 S.A.
The costs for this repair will be covered during the normal warranty.
The regular Warranty procedure will apply.
Below is bulletin VX released:
Field Remedy: 2692
Subject: Front axle suspension - Vibration
Models: Engines: Option:
Insignia 2009... All
Complaint: Slight vibration between 70 mph and 90 mph.
Cause: Addition of tolerances.
Remedy:
In case of customer complaint please exchange the rear bushing
of both lower front control arms. Improved parts can be ordered at
P&A.
Note: Wheels have to be very well balanced and have to be installed
to the hub according to the information given in TIS.
Spare parts: Part-number: Catalogue-number:
Bushing, damper, front- 13 315 674 3 52 496
suspension arm, rear
Labour Times: TC: Hours:
U3 269 20 Replace bushings 90 S.A.
The costs for this repair will be covered during the normal warranty.
The regular Warranty procedure will apply.
Posted May 17, 2015 (8 years ago)
I have replaced 2 more tyres so all 4 are new had the balancing checked so all good Oh all rims checked and good no buckles all bushes arms etc ok etc the shake is there all the time worse when undeload or uphill .
Does anybody think it may be the CV joints inner or outer ?
I cannot think or what else p.s. Shake still there even when in neutral help please
Does anybody think it may be the CV joints inner or outer ?
I cannot think or what else p.s. Shake still there even when in neutral help please
Posted May 26, 2015 (8 years ago)
Have you had a look at this similar problem: Car shudder/shaking whilst accelerating
This message was auto-generated based on a user suggestion.
This message was auto-generated based on a user suggestion.
Posted Aug 21, 2015 (8 years ago)
Gearbox mount
Easy to mis as battery out etc just to check and then not easy best to remove the mount rubber was badly cracked replaced with salvage on with 50k
Job done at last
Easy to mis as battery out etc just to check and then not easy best to remove the mount rubber was badly cracked replaced with salvage on with 50k
Job done at last
Posted Nov 14, 2015 (8 years ago)
Try replacing both drive shafts (near side, offside).
I had the issue and after replacing them is not shaking anymore.
I had the issue and after replacing them is not shaking anymore.
Posted Nov 14, 2017 (6 years ago)
This problem is archived
If you're having a similar problem please click below to re-post this problem, you can then customise it to suit your situation.
Join the community
Got a question? Can you answer other questions here? If so please...
More problems with the 2010 model year Vauxhall Insignia
We have 80 problems and solutions in our database for this model year of the car.
View all Vauxhall Insignia Problems
Insignia Recalls (6)
Parts mentioned