Rover 45 Problems

I had my alternator replaced last week. Since then instead of idling just under 1000rpm and steady the idling speed is lumpy and rises to about 1250 up and down. Any help appreciated.

Passengers side head last.p fog lights and rear stop not working..had all bulbs fitted and fuses checked at hafords The guy said its could be wiring or engine management.. Any ideas..there are some issues before with air bags wires under s...

new battery in last 3 months...jump leads on power there...engine making no effort to turn over...thinking starter motor ?

loud rattling at idle which stops as revs pick up. Now an additional scraping noise as drive is selected and all this after repairs for a broken cam belt by a Derby based garage.

when i unlock the car and do not insert the key right away the immobilizer light on the dash comes on and it beeps also the srs light comes on any ideas. thankyou

I have been driving the car all day with no problem until i wanted to go out this afternoon when i tried to start i had ignition but would not turn so i checked all electrical connections they seemed to be okay, so i thumped the fuel manifo...

car is cutting out when cold but runs great when engine heats up cylinder head skimmed new gaskits belts pumps and every thing done in november mileage is 69 thousand

Engine does run fairly hot . after a good 40 min of motorway +10 mins town driving, neither of the engine fans kick in . But they do activate when I put the A/C on

All the indication lights are showing that the heaters are working but there is no hot or cold air flowing through the car.

hi my rover 45 wont blow cold air no matter what way I turn the dial just hot, what parts do I need to replace or is there a simple solution any help please MIKEY

Car has not been used for a couple of weeks, now will not start. Engine turns over but i think the immobiliser still on, also hazard lights flash. Neither of my immobiliser fobs seem to work. Have renewed batteries. Has anyone any idea's...

Im a bit of a doer,,this ball joint is in upper arm suspension which im replacing,,,the whole thing,,,is it easy ,,i have enough tools