2001 Peugeot 206 Problems

The problem i have is the ignition key will go into the barrel ok and starts the car but when i try to turn off or get the key out it is solid, this only happens every now and then, when it jams i have to wiggle the key until it comes out.C...

I took my car for diagnosis and they reckon it returns an error. I am told that wits computer needs resetting. Is this true?

Hi have a 206 2001 the car has starting pulling to the left while driving not braking, also at the same time the front right makes a cruching sound when putting on full lock retaining clips are there no obvious cracks on suspension also no ...

Hi my peugot 206 Quicksilver 1.4 petrol keeps struggling to go uphill. I topped up the oil recommended by the garage and for a week it ran ok. Suddley the juddering started agai, the engine made avthroaty noise and the oil light came on. I ...

rear wiper end part of stalk should be sitting in off position but is sitting in steady on position can i remove the end and adjust it if so how can i do this. many thanks

Can anyone help? The Boot on my peugeot 206 for some reason is heavy, not sure how or why this has happend. Went to open the boot this weekend and i cam barley lift the boot open. my car is a carbolet. not sure if this is a common problem? ...

ok hi there and hope you can help so this is the problem. its a 206 1400 great car really but the other week i was driveing it and it started to run lumpy as if it was missing from one cylinder and engine management light came on. turned it...

my rear wiper does not stop even when lever is at off position, i currently have the motor unplugged at the rear but as soon as i plug it in the wiper starts. I'm not sure whether i need a new motor or would it be a wiring problem

dear sir, i need to know where the iat sensor is and what it looks like. many thanks.

hi sometimes when i open the car door or boot the hazard lights start flashing for about 20 secs then go off.

I have had the cars ECU decoded as I bought it as a non-starter. It now starts fine but the wipers, indicators and horn do not work and the headlights come on as soon as the engine is started. I had these problems before having the ECU deco...

engine management light on.engine starts good,after a few miles if slowing doown engine cuts out.switch engine off and restart after 10 seconds then goes well untilnext slow down.Dealer changed fuel regulater,fine for 40 miles now back to s...

when driving along no noise or rattle when approching junctions and taking foot off the gas an annoying rattle comes help

whenever it rains heavily my car starts fine then cuts out when i try to move it starts chugging and blowing out what appears to be white steam , i leave it for a minute and it starts moves a little then cuts out again can anyone help????

my break lights are staying on i've had 2 new switch's fitted and the problem keeps happening.

Hi guys i wonder if any one could please help me, I have recently bought a 2001 peugeot 206 1.4 LX.. The problem im having is that when i first drove on the motorway and was doing approx 65mph took my foot of the accelerator to slow down th...

I have a peugeot 206 1.9 diesel.. the fan in the car is not working, when I start the car I am almost blown away, I can't turn it down or switch it off, it is just constantly blowing. Does anyone know what caused that to happen, I have been...

The mil light is illuminated on my 206cc the codes indicate a problem that could be the Map sensor or Lambdas. I have replaced the MAP sensor and both Lambda sensors.I have 2 OBD scanners but neither will reset the fault and put out the mil...

I recently got to the point where the noise of worn clutch thrust brearing got on my nerves so had a local mechanic (In Spain) change the complete clutch assembly and cable. The cable was a genuine Peugeot part but the rest of the assembl...

on accosions the display comes up with gearbox failure then the car will stick in 2nd gear until u pull over and swicth of the ignition an restart