Peugeot 207 Engine & Drivetrain Problems

Hello, I have just become the owner of this car and the last 3 services were done with you. I would be eternally grateful if could check your records and maybe provide duplicate service invoices as the car does not have them and one states...

The car starts an after a few km , begining to send - electric circuit faulty, Abs faulty, eng man system faulty, and the engine die. and it doesn't start anymore. After several hours , starts and die again. please help

moving onto the motorway driving along and wanting to accelerate the car does not accelerate for quite a delay and suddenly jerks forward at speed - this is an automatic gearbox

And starts on number 2 of the key

Running car out of town thermostat runs really low changed the coolant and no better

We have changed the water pump and the thermostat, flushed the hose through the engine all good, however the top radiator pipe is hot and the bottom is cold ! The fan doesn’t kick in at all and it boils out the bottle, the fan works fine ...

Hi to all, My Peugeot 207 cooling fan is not coming on to cool the engine, I have changed the green temperature sensor, thermostat, and fan relay. The temperature gauge reads around 85-90. water is lost from the overflow bottle cover and th...

Engine cuts out when coming to a junction, can start again but gotta get the accelerated getting the revs up else will conk out again. Loss of power, but now it sounds like misfiring and the accelerater is only reacting enough just to get ...

Only runs with the mass air flow meter disconnected . Had a new one fitted still the same so took off .. erg valve done .. very confused any help would be great thanks

I keep getting P1139 fault code, I cant seem to resolve the problem. I have replaced spark plugs and coils but problem keeps coming back. The car is also lacking in power. Any help would be greatly appreciated.

started my car idled for about 15 mins then said oil pressure low then shut itself off left it to cool down checked oil level its ok no oil leak anywhere so tried to start it again said oil pressure ok it turned over sounded really rough no...

Just had the head gasket, cam belt & thermostat done as car overheated, previous owner had filled it with sealer, drives OK but thought the exhaust was blowing had checked by garage and exhaust OK, but the pressure blowing is high coming ou...

Engine management light as com on. And it comes up with depolution fault. Read the ecu and it's saying camshaft position sensor bank 1. code p0341. Where abouts is the sensor. And by replacing the sensor. Will this clear the fault.

I had the car for a period of 23weeks have done just over 2000 miles when oil pressure warning light came on, oil was topped up a week later driving home from work approx 7 mile journey, smoke started coming from engine and stop car warnin...

Engine fan wont turn on. We replaced the fan control assemble but still dosent work properly. The fan works now and again but when it comes on it stops later.

what would happen if white connector were to be used in place of grey connector coil pack ?many thanks

Where does the rubber oil filter seal go when you change the oil filter?

The nearside rear coil spring is incomplete and needs to be replaced before car can pass MOT. Is it essential to replace the offside rear coil spring at the same time?

anybody now how to get to and change oil filter on 207 hdi 1.6 many thanks