Citroen Berlingo Engine & Drivetrain Problems

Van ran really well and has been fully serviced, however it developed an intermittent fault causing the van to stall. The stalling occurred usually at low revs, when cornering or on a roundabout. Aft...

Accelerator tight and not much power when driving need to push accelerator right down

Hi all I have just purchased a 2016 Citroën berlingo van and its got a bad vibration noise coming up through the gear stick my local garage says it's the gearstick ball joint but it seems to be rattl...

Changed cylinder head, Turns and fire's but wont start afterwards. Timing belt adjusted correctly.

Had this problem a few weeks now first time Engine management light came on along with ESP/ASR System fault it was taken in to be repaired i was told DPF Fluid was empty also had AD Blue topped . Then...

Hello I'm getting NOx sensor error P2000, mechanic said need new sensor is it true ? he said this one https://xenons4u.co.uk/9678570780-5wk96746a-sns146a-nox-sensor.html otherwise it wont go away.

Citroen Nemo engine light on and in limp mode 1.4 petrol. Fault code says accelerator but complete second hand accelerator and pedal fitted after one day same code and limp mode. Complete new accelera...

Is there a filter in this transmission

Engine cuts when clutch pedal touched

Turns over but won't start

Have to have high revs to get the car moving once moving revs go back to normal but labours on hills could be firing on 3 cylinders don't know

what is the recommended temperature on a Citroen berlingo

Lack of power lots of smoke ,changed -egr v/v +air emission still no different and engine light is on

When driveing and usually when turning a corner engine will cut out ..car will start again straight away..also speedo only working intermitantly ..could problem be electrical

Temperature sensor (40-99) The cooling fan of the water cycle work when the figure of 110 ° C And temperatures up to 120

My van is high milage 221000.I do 560miles a week but it is well maintained.over the last two years i'v had to have two oil coolers fitted at the cost of100.00pounds plus. I find I need another now....

hard to see oil level on dip stick even after oil change?

Hello again, please tell me why springs are needed where the exhaust is attached to the engine end and do you tighten these fully are just pinch them up ... thanks

new wheel cylinders and shoes fitted

When I start the van from cold,it has an intermittant missfire annd then within 5 or 10 minutes,it goes away. I have put injector cleaner through it and it has had some good runs, but it hasn't change...