AutoInsider Logo
Logged Out | Log In | Sign Up


Home > Problems & Fixes > Ford > Ford Mondeo

Ford Mondeo changed cam position sensor but won't start

2004 Ford Mondeo Problem

Use this reference number to point people to this problem from other problem pagesAutoInsider Ref#: 1900
Use this number to refer to this problem
CarFord Mondeo 2.0 tdci
Year2004
Ownerpaul eck
Posted31/03/2009


More Ford and Mondeo problems
The Problem:

i've changed the cps but car won't start do i have to reset the injector timing



Ads by Google






Solution 1


Suggested Solution

did you replace the short wiring loom
if so re check wires






Posted on Tuesday 31st of March 2009

Don't understand this?
Post a further question on this thread using this form Post a further question



From Original Poster



no didn't change the wiring just the cam sensor but been told might have to reset injecyor timing is this right and thanks for all your help before





Posted on Tuesday 31st of March 2009

Don't understand this?
Post a further question on this thread using this form Post a further question



Solution 2


Suggested Solution

try putting the old 1 back in check around the sensor making sure every thing is secure, p.s does it turn over?





Posted on Wednesday 1st of April 2009

Don't understand this?
Post a further question on this thread using this form Post a further question



Solution 3


Suggested Solution

first make sure you have a fully charged battrery..
check the fuel filter and pipes for leaks!! could just be air present!! if all ok then check all outputs from ecu. if all ok then check for fuel delivery at the injector. if fuel is present then the reprograming of the injectors is required to reset the ecu and immobilizer. if it still wont go after all that then there may be a trigger fault with the crankshaft position sensor. hope this helps!!






Posted on Thursday 2nd of April 2009

Don't understand this?
Post a further question on this thread using this form Post a further question



Solution 4


Suggested Solution

Hi guys

Had a problem on Sunday, never had a misfire or problem with timing before. All of a sudden car wouldn't start.

Usual coil light goin out on ignition then after 3 or 4 seconds on no start flashing.

Put on computer in Ford next day and the cam sensor fault came up. Upgraded sensor put in, still no start, though engine will wind. Same fault is still on the computer. Also had brain removed and tried in another Mondeo, which started fine so it doesn't appear to be the brain.

Pump is fine and cam is turning, and as yet no problems with wiring that Ford can find. Injectors are also fine as fuel pressure is ok. Crank sensor is also good. RPM also ok.

Any help or suggestions very welcome. PLEASE HELP!!






Posted on Wednesday 1st of July 2009

Don't understand this?
Post a further question on this thread using this form Post a further question




Post a solution Post a solution





Sponsored Links



DISCLAIMER
Please note that the comments made here and the suggested solutions are the opinions of the posting user and should not be taken as professional advice. If in any doubt please seek professional advice from your local specialist. Find mechanics in your area using our Auto Local Directory.